Re: [Discuss-gnuradio] Unknown dboard-id

2010-08-06 Thread Josh Blum
DBSRX support is available for the UHD. Modification instructions have been created for dbsrx: http://www.ettus.com/uhd_docs/manual/html/dboards.html#id1 -Josh On 08/04/2010 12:05 PM, Ninja wrote: Hi Josh, Thanks for the info. I just understand the different of UHD based and USRP2-gnuradio,

Re: [Discuss-gnuradio] Unknown dboard-id

2010-08-04 Thread Ninja
Hi Josh, Thanks for the info. I just understand the different of UHD based and USRP2-gnuradio, so tried using non-uhd firmware and fpga (txrx_raw_eth_20100608.bin, u2_rev3-20100603.bin) on sd card, and run usrp2_fft.py, it works as gui is shown up. But I still see 0x002 displayed there (in bo

Re: [Discuss-gnuradio] Unknown dboard-id

2010-08-04 Thread Matt Ettus
On 08/04/2010 09:41 AM, Moeller wrote: Is my impression right, that the dboard id 2 is for the original dbsrx variant and the dboard id 13 ist for the usrp2 patched variant? Yes I was wondering if the programming was successful or not. The modification instructions have no comment about th

Re: [Discuss-gnuradio] Unknown dboard-id

2010-08-04 Thread Moeller
Is my impression right, that the dboard id 2 is for the original dbsrx variant and the dboard id 13 ist for the usrp2 patched variant? I was wondering if the programming was successful or not. The modification instructions have no comment about this. With the id 13 now it's working with the ursp2

Re: [Discuss-gnuradio] Unknown dboard-id

2010-08-04 Thread Josh Blum
Mr ninja, The dbsrx is not yet supported under UHD. That is why dboard id 0x0002 is not recognized. Our daughterboard engineer is working on it this very day; though I cannot make promises as to its release. Regardless, if you intend to use the dbsrx with a usrp2, it will require the clock m

[Discuss-gnuradio] Unknown dboard-id

2010-08-04 Thread Ninja
I tested the usrp2 using uhd_usrp_probe, why is there a warning about unknown dboard-id or dboard-id combination and Unknown value for RX Subdev and TX Subdev (antenna?)?is there some miss when I assembled the device?or it's needed to configure through software? [r...@fedora12 host]# /usr/loca