Hi,
I tried to run mg-gcc --help and the program is not added in properly. I
tried following step by step in the wiki and still no go.
Any ideas?
On 08/28/2010 10:38 AM, Cheaw Wen Guey wrote:
> Thanks Josh.
>
> Found that line of code.
>
> Following your advice, I have tried both methods you me
On 08/28/2010 10:38 AM, Cheaw Wen Guey wrote:
Thanks Josh.
Found that line of code.
Following your advice, I have tried both methods you mentioned and have
run into problems for both.
For the first one, I have followed the install instructions for microblaze
toolkit given on the gnuradio wik
Thanks Josh.
Found that line of code.
Following your advice, I have tried both methods you mentioned and have
run into problems for both.
For the first one, I have followed the install instructions for microblaze
toolkit given on the gnuradio wiki and after setting the path, I tried to
configure
I believe that the gnuradio usrp2 driver defaults to using only RXA for
the BasicRX board. This can be changed by modifying this value in
firmware for lib/db_basic.c to be "true" for the following line:
.base.is_quadrature = false,
As an alternative, I recommend trying the UHD:
http://ettus-a
Hi all,
I started testing my USRP2 at a lower frequency. I have a function
generator generate a 10MHz sine wave on RX-A and RX-B.
However, I am unable to see the signal when I run usrp2_fft.py. To
confirm, I disconnected the signal from RX-A and still nothing. I can only
trace the signal as far a
