Hi
Is there any UHD function that would let me hold the transmission of USRP's
sink block at run time and then resume the transmission again later. I wish to
keep my USRP on standby unless i want to transmit something again. I looked on
sphinx but only found functions that would change paramete
So there's a few things here. First, you're using the old libusrp driver,
which is fine, except it's been deprecated for almost two years. I
recommend using UHD instead, it's not hard to figure out, and we can
provide better support for it.
Second, you have a misunderstanding of how the USRP works
Hi all,
i have been doing my final year project of MIMO-OFDM using gnuradio.
For this i first want to transmit a sine wave and i made a simple
program by the concept used in usrp_siggen.py. Although sine is
recieved successfully and its fft is plotted but it has a very low
amplitude and many harmon
On Fri, Apr 17, 2009 at 03:58:56PM -0700, Somya Ajmera wrote:
> Hi all, Did any body else had a problem while transmitting through
> USRP board? I am using Basic Tx/Rx board. When I tried to send a
> sinusoidal signal of 50Khz (through GRC) and tried to look at at the
> transmitted signal on to th
Hi all, Did any body else had a problem while transmitting through USRP board?
I am using Basic Tx/Rx board. When I tried to send a sinusoidal signal of 50Khz
(through GRC) and tried to look at at the transmitted signal on to the
oscilloscope by probing the Tx SMA connector, it displayed a sinus
