On Wed, Sep 22, 2010 at 2:54 AM, Lebowski80 wrote:
>
> Hello
>
> I'm trying to utilize benchmark_tx.py and benchmark_rx.py using 2 USRPs with
> XCVR2450 Transceivers. When I consider a bit rate equal or greater than 124k
> everything works well. With bit rates smaller than 124k only the
> ./benchm
Hello
I'm trying to utilize benchmark_tx.py and benchmark_rx.py using 2 USRPs with
XCVR2450 Transceivers. When I consider a bit rate equal or greater than 124k
everything works well. With bit rates smaller than 124k only the
./benchmark_tx.py can run, while ./benchmark_rx.py can't receive any sig
Hello Tom,
Looking at your reply to this post, I am wondering how can we then transmit
at carrier frequency around 90-110 MHz? Would we have to use a different
daughterboard? I didn't have any problem transmitting an analog audio signal
over carrier frequency within board frequency range as well
On Thu, Dec 07, 2006 at 12:20:20PM -0700, Tarun Tiwari wrote:
> Thank you Tom,
>
> I did change the bit rate for Rx and used -v mode, but its still not
> working. Please see the output of program:
Since you are using the Basic Tx, try removing the attenuator.
Also, be sure to set the gains on bot
Tarun,
> From: Tarun Tiwari [mailto:[EMAIL PROTECTED]
>
> Thank you Tom,
>
> I did change the bit rate for Rx and used -v mode, but its still not
working. Please see the output of program:
>
> Transmitter:
> [EMAIL PROTECTED] ~]# ./benchmark_tx.py -f 100e6 --tx-amplitude=500 -M 2 -r
100e3 -v
>
advise me.
Thank you again.
Regards,
Tarun
On 12/7/06, Tom Rondeau <[EMAIL PROTECTED]> wrote:
> From: [EMAIL PROTECTED]
[mailto:[EMAIL PROTECTED] On Behalf Of
Tarun
Tiwari
> Sent: Thursday, December 07, 2006 12:25 AM
> To: discuss-gnuradio@gnu.org
> Subject: [Discuss-gnuradio]
> From: [EMAIL PROTECTED]
[mailto:[EMAIL PROTECTED] On Behalf Of Tarun
Tiwari
> Sent: Thursday, December 07, 2006 12:25 AM
> To: discuss-gnuradio@gnu.org
> Subject: [Discuss-gnuradio] Problem using benchmark_rx.py
>
> Hi,
>
> I am trying to transmit packets using benchamar
Hi,
I am trying to transmit packets using benchamark_tx.py and recieve them
using benchmark_rx.py. As mentioned in README file I started first
benchmark_rx.py at one machine then started benchmark_tx.py on another
machine, but I dont see any print on receiver machine. I am using following
command
