Hello all,
Currently, I have the following hardware setup:
Receive Antenna --> Preamplifier --> RF In (USRP2 + DBSRX)
I was wondering if I could use USRP2 to supply power (12- 14V) to the
preamplifier? If yes, can someone tell me how?
Thanks and best regards,
Amee
_
I burned DBSRX usrp2 firmware image (burn_dbsrx_eeprom.bin) as suggested,
but then only F LED turned on and find_usrps command says: No USRP2 found
which was not the case initially.
Then I burned UHD firmware and UHD fpga image from (
http://code.ettus.com/redmine/ettus/projects/public/wiki/U2bina
Hi all,
I am running DBSRX on USRP2.
I have followed the wiki -- Remove R193 and put it on 194.
But I have not burned the firmware `burn_dbsrx_eeprom.bin' as I cannot find
from where. I did find: (root / usrp2 / firmware / apps /
burn_dbsrx_eeprom.c)but when I try to compile it, I get error. Can
Hi,
I am using USRP2 and DBSRX board to receive 2.23 GHz signal. I am using GRC
blocks USRP2 source connected to the FFT sink.
I have modified the DBSRX board as mentioned on the wiki (removing resistor
from R193 and soldering it to R194). But still I don't receive any signal at
any frequency. Al
