Patrik Tast wrote:
Hi All,
At the moment I feed 12 VDC into COAX outside Ettus USRP1 12VDC to power
my LNA. I have a DC-Block
at the receiver to prevent voltage back into the DBSRX-LF REV 2.2.
Connector J100 say Antenna Bias + and GND 500mA @ 6V.
My question is, is it possible to feed 12V
Matt Ettus wrote:
I assume you mean on the USRP1. Change the R divider in constructor
of the db_flexrx_400_{tx,rx}_mimo_b in db_flexrf_mimo.cc
An R divider of 16 (the current setting) make the LO step size 64
MHz/16 = 4 MHz, but the following stage divides it by 2 again for a
step size of 2
Newman, Timothy wrote:
Is it possible to change the tuning step size on the RFX400 to
something different than the 2 MHz step size it's on now? I've been
looking through db_flexrf.cc and have had no luck.
I assume you mean on the USRP1. Change the R divider in constructor of
the db_flexrx_40
Hi All
I am tried to run bbn802.11 , but I faced the following error,
r...@ala-laptop:/sdr/douggeiger/src/examples# ./bbn_80211b_rx.py
Traceback (most recent call last):
File "./bbn_80211b_rx.py", line 37, in
from bbn_80211b_pkt import *
File "/sdr/douggeiger/src/examples/bbn_80211b_pkt.p
Kóczián Gergely wrote:
Hi all!
A have a little probleme with FFT.
I use the GRC without USRP. I would like to messeaure a triangle
signal, but i never becam the right effect. I attached the picture
about the measuring.
The problem are the followed:
I don't why but, i have allways a peak at
Hi,
in your picture is a peak at -12KHz.
Is it possible, that you have to calculate the absolut value from the FFT?
On a normal calculator it's the function abs().
> Hi all!
>
> A have a little probleme with FFT.
>
> I use the GRC without USRP. I would like to messeaure a triangle
> signal, b
Hi all!
A have a little probleme with FFT.
I use the GRC without USRP. I would like to messeaure a triangle
signal, but i never becam the right effect. I attached the picture
about the measuring.
The problem are the followed:
I don't why but, i have allways a peak at 0Hz. - Independent from the
