HSI is not a good choice if there are external interfaces. It can vary too
much part to part and over temperature to meet the 2% across the system
boundary. They claim 1% @25c but that is 1/2 the budget to begin with,
https://www.st.com/resource/en/application_note/dm00425536-how-to-optimize-stm32
Anyone ever use the HSI on STM32F103, how about RET6? I know the code is
set up for HSE. I got it working, at least UART1.
But now, the other usart devices ... Wondering if anyone has ever run into
UART baud rate mismatches on using HSI? I have a few
radios that work great with an existing driver a
Today I test the possibility to exchange PA07 and PB05 as described
here, be removing SB121 and closing SB122 solder bridges on the back of
the nucleo board.
https://os.mbed.com/teams/ST/wiki/Nucleo-144pins-ethernet-spi-conflict
This an HW patch, but quite simple to be done.
Roberto
On 8/23/
On Mon, Aug 22, 2022 at 9:14 AM raiden00pl wrote:
> Do you use the default TIM3 outputs configuration from
> nucleo-144/include/board.h ? It uses PA7 as the TIM3 channel 2 output which
> is also used for RMII_CRS_DV.
>
> From the nucleo 144 user manual:
>
> > 2. PA7 is used as D11 and connected t
Exactly! The problem is there. Setting the PWM channel to
#define GPIO_TIM3_CH2OUT GPIO_TIM3_CH2OUT_2
the problem disappears.
I need this PA07 to connect the Arduino Motor Shield (Motor B)...
I check the JP6, perhaps it solves the conflict.
Thanks and best regards
Roberto
On 8/22/22 15:14
This is my configuration:
#define GPIO_TIM3_CH1OUT GPIO_TIM3_CH1OUT_2
#define GPIO_TIM3_CH2OUT GPIO_TIM3_CH2OUT_1
#define GPIO_TIM3_CH3OUT GPIO_TIM3_CH3OUT_1
#define GPIO_TIM3_CH4OUT GPIO_TIM3_CH4OUT_1
PA07 for PWM channel 2 is required by the Arduino Motor Shield, used to
control an external m
Do you use the default TIM3 outputs configuration from
nucleo-144/include/board.h ? It uses PA7 as the TIM3 channel 2 output which
is also used for RMII_CRS_DV.
>From the nucleo 144 user manual:
> 2. PA7 is used as D11 and connected to CN7 pin14 by default, if JP6 is ON,
> it is also connected to
Hi
I've configured a NUCLEO-F746ZG board with different devices:
* PWM (TIM3 3xOutput)
* QE
* ADC
* GPIO
CONFIG_PWM=y
CONFIG_STM32F7_PWM_MULTICHAN=y
CONFIG_STM32F7_TIM3_PWM=y
CONFIG_STM32F7_TIM1=y
CONFIG_STM32F7_TIM1_QE=y
CONFIG_STM32F7_TIM2=y
CONFIG_STM32F7_TIM2_ADC=y
CONFIG_STM32F7_TIM3=
