+1
- LICENSE, NOTICE and DISCLAIMER files exist.
- Checksum and signature valid
- Can build from source.
Regards
Asif
On 2021/04/18 14:05:50, Alin Jerpelea wrote:
> Hello all,
> Apache NuttX (Incubating) 10.1.0 RC0 has been staged under [1] and it's
> time to vote on accepting i
On Mon, Apr 19, 2021 at 7:19 PM Byron Ellacott
wrote:
> Hi all,
>
> I don't think my test qualifies to give a +1 due to needing a patch for my
> unsupported toolchain, but otherwise it's successful.
Thanks for reporting your results. All input is helpful.
If you own the patch and if you want t
Hi all,
I don't think my test qualifies to give a +1 due to needing a patch for my
unsupported toolchain, but otherwise it's successful.
- LICENSE, NOTICE, README.md, DISCLAIMER-WIP present in both repositories.
- Build for eZ80 requires a custom patch for a non-supported toolchain.
Patch adds
The Infineon Dali Arduino board used a similar Infineon XC836 part that
has a UART interface.
Greg
On 4/19/2021 1:35 PM, Alan Carvalho de Assis wrote:
Hi Greg,
This LW14 is interesting! It is possible to buy a module with it to
use the I2C interface with any board (don't need to be an Arduino
Hi Greg,
This LW14 is interesting! It is possible to buy a module with it to
use the I2C interface with any board (don't need to be an Arduino
form-factor) see:
http://www.saelig.com/product/lw14-02mod.htm
I think the shipping cost will be higher the the product.
BR,
Alan
On 4/19/21, Gregory
Mouser has only this Infineon board:
https://www.mouser.co.cr/datasheet/2/196/AP0810414_LightNet-1840577.pdf
. It is based on an Infineon bridge part that has a USB/UART connection
to the host.
The Hasseb USB Dali Master that you referenced
(http://www.hasseb.fi/shop2/index.php?route=product/
Hi, Murat,
At 95 euros that could be a turn off for some hobbyist. I looked around
for a low cost solution and found two pretty common solutions.
1. Aruino Dali Shield. There are shields like the daliMaster
https://github.com/davideloba/daliMaster that are reasonably priced.
These have an
On Sun, Apr 18, 2021 at 10:06 AM Alin Jerpelea wrote:
> Apache NuttX (Incubating) 10.1.0 RC0 has been staged under [1] and it's
> time to vote on accepting it for release. If approved we will seek
> final release approval from the IPMC. Voting will be open for 72hr.
>
> A minimum of 3 binding +1 v
Hi Greg,
I am going to order this (
http://www.hasseb.fi/shop2/index.php?route=product/product&product_id=50 ) USB
Dali-2 Master unit to start playing and getting familiar with DALI commands.
With this unit I will be able to test our own slave hardware - software as
well. I will share my exp
