The last backports that I know of I just merged this evening. If
anyone has outstanding issues that they think need to be resolved,
please call them out. I would rather we try to deal with known
questions now rather than after the RC is put up for a vote. I would
like to cut the release Thursday
Fixed it (workaround) by opening and closing ADC device. Then the FIFO
cleans. It rather fast and performance is good enough for its purpose.
Op wo 21 okt. 2020 9:33 p.m. schreef :
> Nice.. I just want to use the ADC as feedback sensor for a plunger... I
> all works fine until the FIFO is full 😉
Nice.. I just want to use the ADC as feedback sensor for a plunger... I all
works fine until the FIFO is full 😉
-Oorspronkelijk bericht-
Van: Daniel Pereira Carvalho
Verzonden: woensdag 21 oktober 2020 21:01
Aan: dev@nuttx.apache.org
Onderwerp: Re: NuttX and continuous ADC conversion
M
Maybe you could propose a modification on ADC upper-half driver to enable
overwriting. So, if the FIFO is full the oldest value is replaced by the
new one. This could be an option on the config system.
At this moment I am working on STM32L4 ADC driver. I am implementing the
low level operations, b
You might find this interesting. It's about sensors, but ADCs are just a
voltage sensor so it might be possible to optionally wire the upper half.
https://github.com/apache/incubator-nuttx/pull/2039
On Wed, Oct 21, 2020, 11:48 AM wrote:
> I have implemented a daemon which uses sigaction. And in
I have implemented a daemon which uses sigaction. And indeed the ADC works with
this solution until the FIFO is full... Maybe I have to add an IOCT that resets
the ADC?... Or set the FIFO buffer back? Or make a ringbuffer instead of
FIFO
Ben
-Oorspronkelijk bericht-
Van: Nathan Har
On Wed, Oct 21, 2020 at 2:26 PM wrote:
> Thats correct... so I have to start the conversion every time over
> again... and het the value after that conversion I have seen continuous
> conversions ADC on an STM32...
>
> I will try to find a plausible solution.
>
Zero latency ISR to read ADC
Thats correct... so I have to start the conversion every time over again...
and het the value after that conversion I have seen continuous conversions
ADC on an STM32...
I will try to find a plausible solution.
Ben
-Oorspronkelijk bericht-
Van: Daniel Pereira Carvalho
Verzonden:
If I understand well, you want to put the ADC to continuously sample an
input at some sampling rate.The ADC ring buffer depth will be set to 1 and
should store the value of the last sample. Is that correct?
If yes I think that is not possible because adc_receive() will refuse new
data if FIFO is f
Is it possible to achieve a continuous ADC conversion, where the
sample[0].am_data is written in a struct (and constantly updated) and where I
can get and check the voltage from the ADC?
I have it working that the value I get is true and it also seems to measure the
change, but after some time
10 matches
Mail list logo
