Re: Network Install won't connect

useful. I do hope I didn't get too boring :-) Cheers, LMS == Laurent Steffan [EMAIL PROTECTED] eBusiness Technical Consultant == Reçu de Colin Foran le 11/07/02 à 17:14 >The ifconfig output: >Link encap: Ethernet HW

Re: Network Install won't connect

(Follow-up to my previous message) ATT Broadband does indeed provide the unusual subnet mask that I talked about, so my doubts about this specific point were not founded. Bye, LMS == Laurent Steffan [EMAIL PROTECTED] eBusiness Technical Consultant

Re: Network Install won't connect

So trying to do that with a standard DHCP configuration might not work, just like what you're experiencing. If so, we could probably help you to setup your network so that it works, but I at least would need more information for that. == Laurent Steffan

Re: Network Install won't connect

As for me, nothing much, sorry ! I was going to suggest doing what you've just done, so if it doesn't work I am quite puzzled, especially since it worked on the MacOs. One caveat though : it is likely that the IP address that it gives to your RedHat machine is linked (by your provider) to the Ether

Re: Network Install won't connect

well you know, once you manage to get through ATT's gateway you're able to access the DNS servers, which should resolve the names for you. But I'm not sure I understood your previous message; have you been able to ping the gateway, or establish some kind of communication with anything ? I think the

Re: Network Install won't connect

config". I think the only interfaces that you should see are "eth0" and "lo". Same applies to "route". If you'd like me to look at your configuration parameters, I'm online for another half-hour or so. LMS == Laurent Steffan

Re: netatalk does not see a printer

d see what happens. - my "getzones" command also times out, but that does not seem to have any impact on the printing ability. In particular, nbplkup works (so does printing) both before and after the getzones command. Let me know if you'd like more information. Good luck, LMS

Re: netatalk does not see a printer

Hello Alessandro, I'm glad you managed to make it work. I can understand your happiness at being able to use the Asante bridge, I had the same feeling a few weeks ago :-) Cheers, Laurent == Laurent Steffan [EMAIL PROTECTED] eBusiness Technical Consu