Re: ENE B710 help me

Il giorno ven, 09/09/2005 alle 11.39 +0200, [EMAIL PROTECTED] ha scritto: > help me !!! > how tu run my SD card reader to run. If it is ENE Technology Inc CB710 Memory Card Reader Controller, at this moment is not supported. bye Christian -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a s

Re: No cpufreq interface in kernel 2.6.3?

Hi, active frequency change of the processor can also be controlled using 'powernowd'. First modprobe and then put the following in /etc/modules p4_clockmod cpufreq_userspace and install powernowd # aptitude install powernowd The deamon will check the cpu usage every second, and changes the

Re: ENE B710 help me

did you try to use sudo fdisk -l and mount the dev/xxx to mnt/xxx or the dev its not in the fdisk table? On 09 Sep 2005 11:39:56 +0200, [EMAIL PROTECTED] <[EMAIL PROTECTED]> wrote: help me !!!how tu run my SD card reader to run.This shows my lspci:02:04.0 CardBus bridge: ENE Technology Inc CB

Re: dhclient & switching networks

Nate Duehr wrote: > Derek Broughton wrote: > >>Oooh.. You would have to point that out. Somewhere about 3 months after >>I got _this_ laptop, it occurred to me that I was really supposed to >>report >>the MAC to the network centre, so that they could do that. Of course, I >>never got around to

Re: Re: No cpufreq interface in kernel 2.6.3?

I had the same problem. I had a hard time to figure out that for cpufreq you also have to install (at least a subset of?) the modules freq_table proc_intf I used modconf where I found these modules listet under "kernel/drivers/cpufreq" tagged as "not installed". I am a newby using Debian Sarge

Re: The BogoMIPS value sometimes too low on Intel Mobile P3

[EMAIL PROTECTED] wrote: > Hi folks, > I am running a custom-built kernel 2.6.10 on an Intel Mobile P3 processor. > I discovered that when the USB devices don't work the BogoMIPS value > calculated > is far lower than it should be. For example it is 32 whereas normally it > should > be around 145

ENE B710 help me

help me !!! how tu run my SD card reader to run. This shows my lspci :02:04.0 CardBus bridge: ENE Technology Inc CB710 Cardbus Controller :02:04.1 FLASH memory: ENE Technology Inc: Unknown device 0530 :02:04.2 0805: ENE Technology Inc: Unknown device 0550 :02:04.3 FLASH memory: ENE