Package: installation-reports
Severity: normal
Dear Maintainer,
I installed a daily build onto A64-OLinuXino; contrary to the stable
release (10.2), the networking worked without problems and the
installation went fine almost until the end.
However, the installer apparently didn't event try to i
Hi,
I wasn't sure where to report this, so I'm shooting here.
I recently installed Debian 10.2 on a new machine, and went with manual
partitioning, putting the swap on an encrypted mdraid with a random key,
and the result is that booting the system would have a very large delay
on boot.
In recov
Hello,
Samuel Thibault kirjoitti 27.12.2019 klo 9.42:
> Possible the board needs some non-free firmware?
> Did you try to install firmware-linux-free?
Yes, firmware-linux-free was apparently installed during the base install.
> Also, please post how the network board is detected (e.g. the complete
On Fri, Dec 27, 2019 at 11:32:00AM +0200, Marek Nečada wrote:
>
> See dmesg_install.out for the dmesg output obtained at the end of
> installation and dmesg_postinstall.out for the output of dmesg in the
> installed system. It seems the system does not attempt to bring eth0 up
> during the boot; t
4 matches
Mail list logo
