My 30-2 also has a zerk, original from factory.
Allan RDrumroll 30-2 # 90
From: kelly petew via CnC-List
To: cnc-list
Cc: kelly petew
Sent: Thursday, June 2, 2016 1:16 PM
Subject: Stus-List Location of "grease cup"
Alan,
I saw your post below. My 30-2 has a zerk on the rudder po
On my LF38, I installed a Zerk fitting on my grease cup & I think a lot of C&C
owners probably did the same. The grease cup is about 2" in diameter and about
3/4" deep and is located against the fiberglass housing for the rudder shaft.
Bob
Bob Boyer
S/V Rainy Days (1983 C&C Landfall 38 - Hull
My 35/3 had the grease cup on the rudder post. It is brass, about an inch
to 1.5 inches in diameter with a knurled cap. The whole thing would
unscrew, I'd remove the cap, but the base back in, add grease and put the
cap on.
If you are going to replace it with a Zerk, you might consider putting a
If you have a Zerk on the rudder post sleeve, the previous owner probably
replaced the grease cup with the Zerk. The grease cup on my boat is on the
rudder post sleeve.
AlanBergen
35 Mk III Thirsty
Rose City YC
Portland, OR
On Thu, Jun 2, 2016 at 10:16 AM, kelly petew via CnC-List <
cnc-list@cnc
