Here is the successful job.
21-Jun 08:16 ganymede-dir: Start Backup JobId 109,
Job=BackupCatalog.2005-06-21_08.15.24
21-Jun 08:17 ganymede-sd: 3301 Issuing autochanger "loaded drive 0" command.
21-Jun 08:17 ganymede-sd: 3302 Autochanger "loaded drive 0", result is Slot 3.
21-Jun 08:17 ganymede-sd
Kern,
You were right. Although the syntax I was using was correct, I am
assuming this because my other Schedule definitions are working properly,
that was the problem.
Here is what I had before in the config;
Schedule {
Name = "WeeklyCycleAfterBackup"
Run = Full Pool = Catalog sun-sat at 3:10
Most likely you have a level override in your schedule
On Tuesday 21 June 2005 23:29, Grant wrote:
> Kern,
> I realize that the level is catalog and not full, but here is my job
> definition...
> # Backup the catalog database (after the nightly save)
> Job {
> Name = "BackupCatalog"
> JobDefs
Kern,
I realize that the level is catalog and not full, but here is my job
definition...
# Backup the catalog database (after the nightly save)
Job {
Name = "BackupCatalog"
JobDefs = "DefaultJob"
Level = Full
FileSet="Catalog"
Schedule = "WeeklyCycleAfterBackup"
# This creates an ASCII
You should be using Level=Full not Level=Catalog
On Tuesday 21 June 2005 19:20, [EMAIL PROTECTED] wrote:
> Hello,
> I have been getting this error over the last week or so and I can not
> figure out what is wrong.
> When I run the catalog backup manually from the bconsole it runs fine, I do
> not
Hello,
I have been getting this error over the last week or so and I can not
figure out what is wrong.
When I run the catalog backup manually from the bconsole it runs fine, I do
not change any of the settings.
Below is the output from the director. Any suggestions would be
appreciated
21-Jun
On 21 Jun 2005 at 13:20, [EMAIL PROTECTED] wrote:
> Hello,
> I have been getting this error over the last week or so and I can not
> figure out what is wrong.
> When I run the catalog backup manually from the bconsole it runs fine, I do
> not change any of the settings.
You have pasted us the fai
Hello,
I have been getting this error over the last week or so and I can not
figure out what is wrong.
When I run the catalog backup manually from the bconsole it runs fine, I do
not change any of the settings.
Below is the output from the director. Any suggestions would be
appreciated
21-Jun
