Hi
When attemptin to load snd-emu10k (alsa 1.0.16, kernel 2.6.26-2-686)
i got following error message
# modprobe snd-ymfpci
[89978.686314] ACPI: PCI Interrupt :00:11.0[A] -> Link [LNKD] -> GSI 10
(level, low) -> IRQ 10
[89978.707674] firmware: requesting yamaha/ds1_dsp.fw
[89978.759835] f
i not tested.
- Alsamixer does not show any controls. There is however knobs to adjust
input gain and output level so there is no need for mixer controls
anyway.
--
arimo
---
This SF.net email is sponsored by: Splunk Inc. Do you grep th
out correct
syntax.
--
arimo
---
This SF.net email is sponsored by: Splunk Inc. Do you grep through log files
for problems? Stop! Download the new AJAX search engine that makes
searching your log files as easy as surfing the web. DOWNLOAD
Hi!
On some mixers if only left channel is plugged signal will be fed to both
channels. Try to plub something to input 2 too and listen if input 1 is
still fed to both channels.
HTH
--
arimo
On Thu, 16 Feb 2006, Joshua Cowles wrote:
Well, after a LOT of mostly ALSA-unrelated tinkering
Hi!
I have similar setup, see my comments below:
On Thu, 23 Feb 2006, KUKIMOTO Nobuyuki wrote:
At first, alsamixer can not be controlled.
# alsamixer
No mixer elems found
*
Same here. I use knobs to adjust output level.
2nd, playing audio file(***.wav), it works well. It's very clear
Hi!
On Tue, 28 Feb 2006, KUKIMOTO Nobuyuki wrote:
aplay -D hw:1,0 zzz.wav --->fine
aplay -D hw:1,1 zzz.wav --->not to play sound. (silent)
hw:?,0 and hw:?,1 have differrent output connectors. 0 uses upper rca
connectors and tsr jacks, 1 uses two lower rca connectors just below
upper on
