In data giovedì 14 gennaio 2010 00:08:00, Nils Erik Svangård ha scritto:
> ==
> Opening audio decoder: [pcm] Uncompressed PCM audio decoder
> AUDIO: 32000 Hz, 7 ch, s16be, 6272.0 kbit/87.50% (ratio: 784000->896000)
> Selected a
Hi!
I'm trying to get the most out of my surround system.
Now I'm trying to get LPCM pass through directly to my receiver over S/DIF.
I'm not getting it to work. Could it be that it is supposed to be sent
in 190kHz and the M-Audio Delta 1010LT only support up to 96kHz?
This is what mplayer says:
l
2010/1/9 Nils Erik Svangård :
[snip]
> I have some lingering questions:
> -Can I somehow fix so I dont have to use Envy24control to change
> these settings? Can I do it dynamiclly on the fly?
Perhaps the iecset command could help?
It has boolean options for audio mode and professional mode.
But I
Solved it!!! :D
After a couple of hours of trying different combinations of settings I
finally found what was wrong!
For AC3 or DTS pass through in Envy24Control must be set:
-Hardware Settings:Professional:Data-Mode = Non-audio
-Patchbay/Router:S/PDIF OUT (L) = S/PDIF OUT (L)
-Patchbay/Rout
> You can't output more than 2 channels over SPDIF using PCM. To do this you
> have to use a compressed audio stream (Dolby Digital, DTS, etc.)
>
Ah, ok that is good to know! Can the 1010LT card send activity on its
diffrent channels as DTS, Dolby Digital or anything else. Eg. can I
from Ardour pi
> Make sure you have a Dolby or DTS surround file and try to play it with
> mplayer
>
I think I have. I have downloaded some from the net.
If I have activity on 5 channels when watching in Envy24Control is the
PCM-stream that is sent from the card automaticly compressed into DTS
or any other stand
Op Thu, 07 Jan 2010 00:35:08 +0100 schreef Nils Erik Svangård
:
> Hi!
> I'm having trouble getting surround sound working with my M Audio
> Delta 1010LT over S/PDIF.
>
> When I run:
>> speaker-test -Dplug:surround40 -c4 -l1 -twav
>
> It seems that all channels have been mixed into my two front s
Hi!
I'm having trouble getting surround sound working with my M Audio
Delta 1010LT over S/PDIF.
When I run:
> speaker-test -Dplug:surround40 -c4 -l1 -twav
It seems that all channels have been mixed into my two front speakers,
no sound on my two rear speakers.
I have tried playing movies via mplay
