On 15.08.2016 20:01, Philipp Klaus Krause wrote: > Hello, > > I wrote my first little mcs51 program today, for the Cypress FX2LP. But > I encountered a problem: Timer 1 runs too fast. When I set up Timer 0 > and Timer 1 the same, Timer 1 runs about 4 times faster. > > I first noticed the problem when trying to do a software UART, which > worked with Tiemr 1, but not with Timer 2. > > I have attached programs for a 2-bit counter on the LEDs of my board a > bits 0 and 1 of port A. With Timer 1, the counter increments once per > second.
The previous two paragraphs were meant to be: I first noticed the problem when trying to do a software UART, which worked with Tiemer 0, but not with Timer 1. I have attached programs for a 2-bit counter on the LEDs of my board a bits 0 and 1 of port A. With Timer 0, the counter increments once per second. > I compile my programs using > sdcc -mmcs51 test2.c > and put them onto the FX2LP using > cycfx2prog prg:test2.ihx run > > Philipp ------------------------------------------------------------------------------ What NetFlow Analyzer can do for you? Monitors network bandwidth and traffic patterns at an interface-level. Reveals which users, apps, and protocols are consuming the most bandwidth. Provides multi-vendor support for NetFlow, J-Flow, sFlow and other flows. Make informed decisions using capacity planning reports. http://sdm.link/zohodev2dev _______________________________________________ Sdcc-user mailing list Sdcc-user@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/sdcc-user
