When I checked with the oscilloscope on the power supply regarding its
stability, the supply voltage is very consistently regulated at 5V and the
raw power supply voltage consistently at ~15V.
Jan, I'm currently building the project using Piklab after I have the newest
version successfully installed along with the newest version of sdcc source
installation. Should I be switching to using a manual Makefile to build the
project?
Thanks,
Stanley
On 9/29/07, Maarten Brock <[EMAIL PROTECTED]> wrote:
>
> Stanley,
>
> > How can I tell whether I have a problem with my power supply?
>
> I think the only answer can be: use an oscilloscoop and look at the value
> and stability of your power supply.
>
> Maarten
>
> -------------------------------------------------------------------------
> This SF.net email is sponsored by: Microsoft
> Defy all challenges. Microsoft(R) Visual Studio 2005.
> http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/
> _______________________________________________
> Sdcc-user mailing list
> Sdcc-user@lists.sourceforge.net
> https://lists.sourceforge.net/lists/listinfo/sdcc-user
>
-------------------------------------------------------------------------
This SF.net email is sponsored by: Microsoft
Defy all challenges. Microsoft(R) Visual Studio 2005.
http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/
_______________________________________________
Sdcc-user mailing list
Sdcc-user@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/sdcc-user
