Can you share with us (or just me) about what config you have? Are you using the
/ect/reader.conf as in the kit (and installed as
root) or was it from linuxnet.com directly?
Does the ttys0 (or ttys1) have the right priviledges set?
I haven't tried with RedHat 6.0 but 6.1 worked fine on my Inspiron 7500 (with Pentium
III 500MHz) as well as with Pentium 90MHz box
(Digital 590).
Danny
Damir Ivankovic wrote:
> Hello everyone, Recently I purchased Linux Development Kit wit Schlumberger
>Reflex 60 reader and couple of Access cards. I
> connect it to serial port (which is working properly) but I keep getting error
>message: "Open Port 102F8 Failure" What is
> wrong, reader, driver or something else ? I get same message on two different
>machines (one running Reda Hat 6.1 and other Red
> Hat 6.0), both versions of pcsc-lite (0.5.5), RPC or non RPC version, and on both
>COMM ports.By damir [EMAIL PROTECTED]
--
[EMAIL PROTECTED] Smart Card Engineer, Schlumberger APC
TEL/FAX: +1 512-331-3727 8311 N RR 620, Austin, TX 78726 U.S.A.
Crypto-enabled Java Card at: http://www.cyberflex.slb.com/
***************************************************************
Linux Smart Card Developers - M.U.S.C.L.E.
(Movement for the Use of Smart Cards in a Linux Environment)
http://www.linuxnet.com/smartcard/index.html
***************************************************************
