I tried to update the function code as per the documentation, but the scanner gives an error. I have sent email to Fujitsu asking for advice.
allan On Tue, Mar 4, 2014 at 9:06 AM, m. allan noah <kitno455 at gmail.com> wrote: > The protocol document says that the initial value can be changed, but > then goes on to say that no scanners support this command. That type > of thing is sometimes an error in the documentation. I will have to > try it myself to see if it works. > > allan > > On Tue, Mar 4, 2014 at 2:27 AM, Simon Matter <simon.matter at invoca.ch> > wrote: >> Hi Allan, >> >> Did you already find the time to look at this? >> >> Regards, >> Simon >> >>> The fujitsu sane backend does not support software changes to that >>> setting, because it was effectively read-only in older scanners. I >>> think the newer machines might support software control of that value. >>> I will try to find some time to look at that this weekend. >>> >>> allan >>> >>> On Fri, Feb 28, 2014 at 6:35 AM, Simon Matter <simon.matter at invoca.ch> >>> wrote: >>>> Hi, >>>> >>>> I'm using sane-backends-1.0.24 to access a new Fujitsu fi-7160. >>>> >>>> The manpage shows this in the Sensor section: >>>> >>>> --function <int> [0] [hardware] >>>> Function character on screen >>>> >>>> My question is, is there a way to set a sensor value by software, not >>>> using the buttons on the device? >>>> >>>> The main question is because Fujitsu has changed the default function to >>>> 0 >>>> in the newest device series while it was 1 in older devices like the >>>> fi-6130. >>>> >>>> Regards, >>>> Simon >>>> >>>> >>>> -- >>>> sane-devel mailing list: sane-devel at lists.alioth.debian.org >>>> http://lists.alioth.debian.org/cgi-bin/mailman/listinfo/sane-devel >>>> Unsubscribe: Send mail with subject "unsubscribe your_password" >>>> to sane-devel-request at lists.alioth.debian.org >>> >>> >>> >>> -- >>> "The truth is an offense, but not a sin" >>> >> >> > > > > -- > "The truth is an offense, but not a sin" -- "The truth is an offense, but not a sin"
