On 27/03/2013 23:12, Dominik Kopp wrote:
> Hi,
>
> does my scanner MD6228 (ID 0461:0377) support the hardware buttons?
> (probably equal to Medion MD 5345)
>
> Because the buttons (OCR, email, copy...) in skanlite as well as in xscan
> are grey.
>
> And scanimage -A shows:
>
> All options specific to device `genesys:libusb:004:003':
> Scan Mode:
> --mode Color|Gray|Lineart [Gray]
> Selects the scan mode (e.g., lineart, monochrome, or color).
>
> ...
>
> than the vertical resolution this disables horizontal interpolation.
> --color-filter Red|Green|Blue [Green]
> When using gray or lineart this option selects the used color.
> Sensors:
> --scan[=(yes|no)] [no] [hardware]
> Scan button
> --email[=(yes|no)] [no] [hardware]
> Email button
> --copy[=(yes|no)] [no] [hardware]
> Copy button
> --ocr[=(yes|no)] [no] [hardware]
> OCR button
> --power[=(yes|no)] [no] [hardware]
> Power button
> Buttons:
> --clear-calibration
> Clear calibration cache
>
> --------
>
> Dominik
>
>
Hello,
yes they are fully supported. Xsane render them in grey because
they are read only options. You can test them by:
- pressing a button
- check any other option in Xsane 'advanced options' panel
Then you'll see the checkbox corresponding to the pressed button checked.
Regards,
Stef
