On Wed, 22 Apr 2009 08:01:36 -0400 Marc Deslauriers <marcdeslauriers at videotron.ca> wrote:
> > > Any ideas? > > > > try enabling some debug by setting the env > > SANE_DEBUG_EPSON2=12 > > > > Ah! I was wondering why SANE_DEBUG_EPSON wasn't working for me. Of > course, it's the epson2 driver! Is there a man page for epson2? no, but you can take man epson and add a "2" :D > Here is the log: ok, the are a couple of issues: > [epson2] sane_epson2_open: name = libusb:001:007 > [epson2] init_options > [epson2] open_scanner > [epson2] esci_reset > [epson2] e2_cmd_simple: size = 2 > [epson2] e2_send: ESC @ > [epson2] e2_recv: expected = 1, got = 0 > [epson2] e2_txrx: rx err, Error during device I/O > [epson2] e2_cmd_simple: failed, Error during device I/O reset fails. strange but should not harm. > [epson2] tpu status : 0xc0 > [epson2] installed > [epson2] enabled > [epson2] device type : 0x00 > [epson2] main body status: 0x00 > [epson2] sane_epson2_start: scanning... > [epson2] e2_start_ext_scan > [epson2] e2_send: FS G > [epson2] e2_start_ext_scan: fatal error > [epson2] sane_epson2_start: start failed: Error during device I/O > scanimage: sane_start: Error during device I/O > [epson2] e2_recv: expected = 1, got = 0 mmm TPU is enable but can fails. probably incorrect parameters. can you try without giving parameters to scanimage, just the tpu ? you might eventually isolate this section of the log, using a higher log level to see if there's any clue. maybe Olaf knows more -- Best regards, Alessandro Zummo, Tower Technologies - Torino, Italy http://www.towertech.it
