Am Dienstag, 10. Juni 2008 21:09:58 schrieb stef: > > Thanks, this works fine! The starting point at the top of page > > varies only between 0,4...0,8. > > > > But --resolution 100 (I have short tested with others, but seen > > only with 100) the old problem sometimes: The scanner head > > starts to shake and does not move properly. Sometimes means > > about 30 %. > > > > (Log comes direct to you.)
> I've inspected the log. The only difference I can see with a > 'reference' run here is that the hack used to reset the AFE isn't > trigger here. Since I believe this issues are related to > powersaving, could check if your linux kernel has been built with > CONFIG_USB_SUSPEND=y ? The config file used to build kernel is > often stored in /boot. > I configured my kernel without it. It may be the difference. Hello, /boot/config-2.6.22.17-0.1-default contains: . . . # # USB support # CONFIG_USB_ARCH_HAS_HCD=y CONFIG_USB_ARCH_HAS_OHCI=y CONFIG_USB_ARCH_HAS_EHCI=y CONFIG_USB=m # CONFIG_USB_DEBUG is not set # # Miscellaneous USB options # CONFIG_USB_DEVICEFS=y # CONFIG_USB_DEVICE_CLASS is not set # CONFIG_USB_DYNAMIC_MINORS is not set # CONFIG_USB_SUSPEND is not set <--------- # CONFIG_USB_OTG is not set . . . I'm not sure that it is, what you searching. I use: Suse10.3 2.6.22.17-0.1-default By the way: I've seen the same problem (scanner head starts to shake) on a Window-PC. (My scanner was earlier on a other PC.) -- Viele Gr??e Werner Holtfreter
