Hello again, By writing 0x6c=0x12 I have no more power-up problem and pressing buttons have no more effect on stopping head. Oufff!!!!
I tryed with 0x1a=24 and 0x16=02 : black image. Remaining problem : nibbles and calibration. Regards. Guillaume Guillaume Gastebois a ?crit : > Hello, > > Today : regression !!!! > > I tryed to remove lide 35 gpio sequence and to write 0x6b=0x6b & 0x03. > The result was : the motor try to move the head to home (but head is > still home position). When I press a button, the scanner make a scan and > ... don't stop at the end. I see that pressing a button makes that the > head stops. I don't understand because in windows snoop only > GPIO14,13,12 and 11 moves. > > I tryed writing 0x16=02 and 0x1a=24 and I get an "Extremely low > Brightness detected...." (I must open the trap to avoid this and get > some black image...) > > Regards > Guillaume > >
