Using a network port scanner and a remote graphical scanner I cannot get either to show or connect to port 6566. If I then issue the command saned I again get no acknowledgement of port 6566 but if I issue saned -d6 my graphical scanner connects from a remote computer and my network port scanner shows port 6566 as available.
Any reason why this may be? I was under the impression that the -d flag was to run saned in debug mode rather than assist or enable a connection. The only reason I am experimenting with command entries is that I do have inetd installed and working and have followed the MAN saned instructions I cannot get an acknowledgement of port 6566 Geoff Lane Welwyn Hatfield Computer Club www.whcc.co.uk
