Hello, O.S. Fedoracore 4 kernel 2.6.11 Up to now I have not managed to run xsane. here are the results of sane-find-scanner: # No SCSI scanners found. If you expected something different, make sure that # you have loaded a SCSI driver for your SCSI adapter. # Also you need support for SCSI Generic (sg) in your operating system. # If using Linux, try "modprobe sg".
found USB scanner (vendor=0x04b8 [EPSON], product=0x0101 [Scanner GT-7000]) at libusb:002:003 # Your USB scanner was (probably) detected. It may or may not be supported by # SANE. Try scanimage -L and read the backend's manpage. # Not checking for parallel port scanners. # Most Scanners connected to the parallel port or other proprietary ports # can't be detected by this program. scanimage -L device `epson:libusb:002:003' is a Epson GT-7000 flatbed scanner Those information are O.K. however I observe that in the file /proc/bus/usb/devices the driver=none ??? When i submit xsane the program runs normally at the beginning but it hangs when I want to scan a document and after a while I got this message: Failure to start the scanner Error I/O on the peripherical. I have modified the epson.conf according to the Howto and Faq but I confess that I have not found the good answer to solve my problem. I would appreciate if somebody could give me a piece of advice. My Thanks Fran?ois Baert
