some more tests get me some new results. 1 - I have noticed that with 3 different USB 2.0 cards, that the scanner will not register itself as a USB 2.0 device, it only registers as a 1.1 (CD Wiriters register as 2.0, so I know that the card and the kernel are recognizing it properly)
2 - I moved the scanner to the built-in USB 1.1 port, and I was able to finish a scan at 300 DPI and 600 DPI (although it takes quite some time) 3 3 - 1200 DPI still hangs, and letting it sit, I get: error during read: error during device I/O. any suggestions? thanks On Wed, 6 Oct 2004 13:22:31 -0500, Chris McKeever <techj...@gmail.com> wrote: > I have been wrestling with this for a while now, and not turning up > much through searching the web. I have installed SANE > sane-backends-1.0.14 and have a CANON lide30 scanner. > At low resolutions it will process fine. If I go to 300 is fails at > about 75% and anyhting higher wont even start. > > I had it working with an LIDE20 - until that unit crapped out - the > optic bar would just pin itself to the edge and grind. > > I am connecting to the SANE backend via XSANE from a remote linux box > as well as a remote windows box - very similar results (the connection > itself works, just scanning isnt working well) > > Any suggestions? > > thanks >
