On 22/08/2004, at 19:10, Terje J. Hanssen wrote: > Henning Meier-Geinitz wrote: > >> >> On Wed, Aug 18, 2004 at 06:21:15PM +0200, Terje J. Hanssen wrote: >> >>>> I would just add that I am also able to run "xscanimage" after the >>>> sane >>>> installation. But as far as have seen, the xscanimage is set up for >>>> flatbed scanning only and with no selection for ADF. >> >> >>
[..cut..] >> 2) epson.conf: > > My /etc/sane.d/epson.conf file contains only one line that is not > commented out: scsi epson > > 3) scanimage: > > # scanimage -L > device `epson:/dev/sg0' is a Epson Perfection1640 flatbed scanner > > # scanimage -d epson:/dev/sg0 > run flatbed scanning > > scanimage -h shows all options available. There is listed an option > "--source flatbed|Automatic Document Feeder" > I tried something like > > # scanimage -d epson:/dev/sg0 --source Automatic Document Feeder > This syntax was obviously not correct. Can someone tell me how it > should > looks like to scan from the ADF? > I use in an application and work OK (but using USB): scanimage --batch="out%.4d.pnm" --batch-start=1 --mode Color --resolution 75 -t 5 -l 5 -x 125 -y 160 --source "Automatic Document Feeder" > 3) xscanimage: > > # xscanimage -ANE > didn't work. Is this the correct syntax to scan from the ADF? > [..cut..] > > Thanks, > Terje J. Hanssen > > > -- > sane-devel mailing list: sane-devel@lists.alioth.debian.org > http://lists.alioth.debian.org/mailman/listinfo/sane-devel > Unsubscribe: Send mail with subject "unsubscribe your_password" > to sane-devel-requ...@lists.alioth.debian.org > > Javier Diaz-Reinoso Web: http://homepage.mac.com/javier_diaz_r/
