On Sat, 16 Nov 2002, Henning Meier-Geinitz wrote:
> Hi,
>
> Some general comments:
>
> 1) This is not a write-only list. Please read the comments we write
> and, if something is unclear, respond to them.
> 2) Please don't make up a new subject for every article you write. Stay
> in the same thread, just reply to you own or somebody else article
> in this thread. Otherwise we must search the list for your name to
> find out what you aleady tried.
>
> On Sat, Nov 16, 2002 at 02:13:36PM -0700, Karl F. Larsen wrote:
> > I read "man sane-plustek" 4 times. It said clear as a bell that
> > ALL I need in the file plustek.conf is 2 lines. Here is what I have now
> > on this computer:
> >
> > # Plustek-SANE Backend configuration file
> > # For use with Plustek parallel-port scanners and
> > # LM9831/2/3 based USB scanners
> >
> > [usb] 0x04b8 0x01f
> > device /dev/usb/scanner0
>
> Either remove the ids after the [usb] line completely or at least use
> the correct ones. It has been already said that the product id is
> 0x010f, not 0x01f or any other variant of this.
What happened Henning is that sane-for-scanners found the right
one because perhaps, even though the product is wrong in plustek.conf
file.
>
> The scanner is still found by sane-find-scanner?
>
> If nothing else helps, create a plustek.conf file with nothing but:
>
> [usb]
> device /dev/usb/scanner0
>
> > It can't be much simpler than that, and that is what the man
> > page said to do. Alas when I try Xsane and scanimage it comes up with
> > "Can't find scanner".
>
I corrected the product to 0x010f and now Xsane comes up and
WORKS! It was my sloppy written stuff that got me.
> Please send us the debug.log generated by:
>
> SANE_DEBUG_PLUSTEK=255 scanimage -L 2>debug.log
>
> > At this point I'm dead. I don't understand sane, and if the man
> > page is wrong then what is right?
>
> The man page is not wrong as far as I can see.
>
> > Since 0x04b8 means Epson do you think sane is looking for Epson.conf?
>
> No.
>
> > I only have plustek.conf in /etc/sane.d/.
>
> What do you mean by that? Did you remove all the other config files?
> In this case you destroyed your sane installation. Please reinstall.
> You need at least dll.conf.
>
> Bye,
> Henning
> _______________________________________________
> Sane-devel mailing list
> sane-de...@www.mostang.com
> http://www.mostang.com/mailman/listinfo/sane-devel
>
>
--
- Karl Larsen k5di Las Cruces,NM Az ScQRPions -
