I installed on my PC SUSE Linux Version 7.2 (Personal Edition). I have an ADAPTEC-SCSI Adapter AVA-1505 installed in my System and a Mustek Scanner MFS-12000CX is extern connected to the adapter.
The SCSI driver is loaded with the command "Modprobe aha152x aha152x=0x140,10,7,0" in the init.d/boot.local When I boot the system the scanner ist recognized as shown below: Host: scsi0 Channel:00 Id:06 Lun:00 Vendor: MUSTEK Model: MFS-12000CX Rev. 4.02 Type: Scanner ANSI SCSI revision: 00 When I use the command CAT /PROC/SCSI/SCSI the scanner is also recognized as shown above, but the ANSI SCSI revivison is shown as: ffffffff The scanner is also available under "XSANE" When I start the preview or to scan, the scanner starts scanning about 10 % of the object to scan and is then going back to the start. The result of scanning are only stripes. I do not get any error messages. I tried the same with a SCSI Adapter AVA-1505AE but with the same results. I checked everything including all available documentation and found no solution. The internal to the AVA-1505 connect SCSI devices (CD-ROM and Tapestreamer) are working correct. I would appreaciate, if you can help me making the scanner working. Regards, Gernot Keller
