On Thu, 2013-07-25 at 19:14 +0000, dahopk...@comcast.net wrote: > Thank you for the very quick response. But in trying to follow the > suggested link, there are few steps are different. > > First, Step 3 is to install various packages. I already have > auth-client-config installed which had installed libpam_ldap and > libnss-ldap since I simply pulled this system into the test > environment rather than rebuild from scratch. I have uninstalled these > and then added libnss-ldapd and libpam-ldapd along with the kerberos > packages.
Perfect. > Issue is that I was never asked for a Kerberos realm or IP of the > DC. I should have mentioned that this system is running 10.04, not > 12.04. So .. which config file do I need to edit to ensure that the IP > of the DC is correctly specified? DNS does that so you don't need to. Just run: sudo dpkg-reconfigure krb5-config or simply copy /usr/local/samba/private/krb5.conf from the DC to /etc on the client For good measure add the DC to /etc/hosts on the client. > I also installed nslcd. > Correct. > Step 6: I already have samba-common, and samba-common-bin (latest for > 10.04) installed. 10.04 . Did these go in OK? sasl2-bin libsasl2-2 libsasl2-modules libsasl2-modules-gssapi-mit > I'd assume I need to uninstall these and install samba4 instead > (especially as step 8 is to join the domain). > No. You only need enough of samba on the client to get the net command to join the domain. Any old version of samba will do. What you have is more than enough. HTH Steve -- To unsubscribe from this list go to the following URL and read the instructions: https://lists.samba.org/mailman/options/samba