On a side note to Dirk, is there any way you can have SA do the following: when started as an app, check to see if the service is running, if so change some aspect of the GUI to show this. when started as a service, check to see if the process is running, if so throw a msgbox alert showing this It seem that there's an inordinate amount of confusion regarding the potential conflict of running both, and maybe a visual hint will help users along.
Michael D. Shook Systems Analyst - Data Integration Saddle Creek Corporation 863 668 4477 (work) 863 665 1261 (fax) My time zone: UTC -0400 (Eastern Daylight Time) -------------------------------------------------------------------------------- From: Servers Alive Discussion List [mailto:[EMAIL PROTECTED] On Behalf Of Dirk Bulinckx Sent: Tuesday, October 23, 2007 3:26 AM To: Servers Alive Discussion List Subject: RE: [SA-list] Update interface during cycle check not 'sticking' could it be that you're running service and app at the same time? Dirk Bulinckx. From: Servers Alive Discussion List [mailto:[EMAIL PROTECTED] On Behalf Of Clarke, Garry (Systems Manager) Sent: Tuesday, October 23, 2007 9:01 AM To: Servers Alive Discussion List Subject: [SA-list] Update interface during cycle check not 'sticking' Running v 6.1.2171 and a stop/start of the service unchecks the tick box for this setting. _____________________________________________________________________ The information contained in this e-mail communication may be confidential. You should only read, disclose, re-transmit, copy, distribute, act in reliance on or commercialise the information if you are authorised to do so. If you are not the intended recipient of this e-mail communication, please immediately notify the sender by e-mail and then destroy any electronic or paper copy of this message. Any views expressed in this e-mail communication are those of the individual sender, except where the sender specifically states them to be the views of PBLMedia. PBLMedia does not represent, warrant or guarantee that the integrity of this communication has been maintained nor that the communication is free of errors, virus or interference. To unsubscribe send a message with UNSUBSCRIBE as subject to [email protected] If you use auto-responders (like out-of-the-office messages), then make sure that they are not send to the list nor to the individual members of the list that send a message. Doing this will get you removed from the list. To unsubscribe send a message with UNSUBSCRIBE as subject to [email protected] If you use auto-responders (like out-of-the-office messages), then make sure that they are not send to the list nor to the individual members of the list that send a message. Doing this will get you removed from the list. -------------------------------------- The information contained in this message is intended only for the use of the addressee. If the reader of this message is not the intended recipient or agent of the intended recipient, you are hereby notified that any dissemination, distribution, or copying of the message is strictly prohibited. To unsubscribe send a message with UNSUBSCRIBE as subject to [email protected] If you use auto-responders (like out-of-the-office messages), then make sure that they are not send to the list nor to the individual members of the list that send a message. Doing this will get you removed from the list.
