The whole sage was build with this configuration!!!! Should I retry compilation with systemwide "giac complex" installed and just don't use system python? Does anyone care?
Kind regards, Tobias Tobias Weiss schrieb am Montag, 30. November 2020 um 14:21:55 UTC+1: > Sagelib compilation worked now, make continued with certifi package. What > did I you? At first I uninstalled the whole "giac complex" which contains > giac, im, arb, flint, ppl, cddlib pari, sympow - devel, binary libraries > and executable packages. > > But that was not enough: the problem occures with system python38-devel - > so I unsinstalled that package. > > Then I configured like this: > > *./configure --with-system-arb=no --with-system-cddlib=no > --with-system-flint=no --with-system-flintqs=no --with-system-giac=no > --with-system-iml=no --with-system-pari=no --with-system-pari_galdata=no > --wi* > *th-system-pari_seadata_small=no --with-system-ppl=no > --with-system-python3=no --with-python=PYTHON3* > > Waiting some hours and that worked for sagelib. If I need to install the > giac complex I don't know. But I hope this prevents me for the pynac error > I posted before - there flint or pari was maybe compiled two times. > > I let you know if the whole complilation works. > > > Tobias > > > dim...@gmail.com schrieb am Samstag, 28. November 2020 um 23:52:32 UTC+1: > >> If your Sage build is incomplete, some packages have been built, say, >> pari, and then you decide to replace pari >> with a system package then you need to uninstall it. >> In your config.log there is >> >> configure:38410: result: pari-2.11.4.p0: >> already installed as an SPKG >> >> e.g. for pari you'd need to run >> >> make pari-clean >> >> The easiest is to clean everything already built by running >> >> make distclean >> >> and then start again, by running ./configure >> If it is happy about system's pari, you will see >> >> configure:38410: result: pari-2.11.4.p0: >> using system package; SPKG will not be installed >> >> in the output of ./configure (and in config.log) >> > -- You received this message because you are subscribed to the Google Groups "sage-support" group. To unsubscribe from this group and stop receiving emails from it, send an email to sage-support+unsubscr...@googlegroups.com. To view this discussion on the web visit https://groups.google.com/d/msgid/sage-support/3482beb6-3d5d-4dd6-ba6b-c5dbcc1d9e2cn%40googlegroups.com.
