p11 and p10 both fail to resolve the problem. dpkg-dev installed and fully
updated.
Thank you for the suggestion though!
On Tuesday, May 21, 2013 2:44:29 PM UTC-5, leif wrote:
>
> kcrisman wrote:
> > On May 21, 1:57 pm, ghm...@mst.edu wrote:
> >> Just checking in, I replaced the python install retrieved by Sage with
> the
> >> downloaded Python spkg, with no change in error message. Any other
> ideas?
> >>
> >
> > I'm not sure what you mean by this. What you'd have to do is remove
> > the python-x.y.z.spkg in spkg/standard, replace it with the one I
> > uploaded, and then try make. At any rate, the underlying cause here
> > is almost certainly the same as at the ticket in question.
>
> As already suggested, I'd try the .p11 spkg. (You shouldn't have to
> delete the .p9 or .p10, but in any case you have to copy the new /
> alternate Python spkg into $SAGE_ROOT/spkg/standard/. Afterwards simply
> type 'make' again.)
>
> If it's a (short-term) option for you, use Lucid (10.04.4 LTS) in the
> VM, which doesn't have those problems.
>
> Otherwise also make sure you have 'dpkg-dev' installed ("sudo apt-get
> install dpkg-dev").
>
>
> -leif
>
> --
> () The ASCII Ribbon Campaign
> /\ Help Cure HTML E-Mail
>
>
--
You received this message because you are subscribed to the Google Groups
"sage-devel" group.
To unsubscribe from this group and stop receiving emails from it, send an email
to sage-devel+unsubscr...@googlegroups.com.
To post to this group, send email to sage-devel@googlegroups.com.
Visit this group at http://groups.google.com/group/sage-devel?hl=en.
For more options, visit https://groups.google.com/groups/opt_out.
