Hi Jeff, here's the text from the draft that describes the behavior on the BFD system: If the Detection timer at the egress LER expires it MUST send BFD Control packet to the ingress LER with the Poll (P) bit set, Status (Sta) field set to Down value, and the Diagnostic (Diag) field set to Control Detection Time Expired value. The egress LER sends these Control packets to the ingress LER at the rate of one per second until either it receives the valid for this BFD session control packet with the Final (F) bit set from the ingress LER or the defect condition clears and the BFD session state reaches Up state at the egress LER.
Regards, Greg On Mon, Feb 18, 2019 at 9:34 AM Jeffrey Haas <jh...@pfrc.org> wrote: > On Mon, Feb 18, 2019 at 08:48:08AM -0800, Greg Mirsky wrote: > > As for your question of what is the change proposed in the draft I'll > point > > to section 6.6 RFC 5880 that describes the Demand mode. It states that > the > > periodic transmission of control messages MUST be stopped. > > Correct. > > > The draft > > defines, and that is what I consider the update to section 6.6, the > > procedure by which the system in Demand mode initiates the Poll sequence > to > > inform the remote BFD system of RDI. > > Would you clarify where in your draft this is discussed? > > > Greg > > -- Jeff >
