Muthu,
Regarding the question in your 2nd email “Do we know of any implementation that 
provides RLFA FRR protection to multihop BFD packets?”
My employer (ECI Telecom) has implemented multi-hop IP BFD protected by IP FRR 
(including local and remote LFA) with encapsulation that follows RFC 5883.
(As explained by Stephane, IP FRR does not differentiate between multi-hop IP 
BFD and any other native IP traffic to the protected destination).
Multi-hop IP BFD is used for reliable and reasonably fast detection of failure 
of iBGP peers that, in its turn,  can trigger appropriate protection mechanisms.

Regards,
Sasha

Office: +972-39266302
Cell:      +972-549266302
Email:   alexander.vainsht...@ecitele.com

From: Rtg-bfd <rtg-bfd-boun...@ietf.org> On Behalf Of Muthu Arul Mozhi Perumal
Sent: Thursday, January 17, 2019 1:02 PM
To: stephane.litkow...@orange.com
Cc: rtg-bfd@ietf.org
Subject: Re: Can Multihop BFD be protected using RLFA backup?

Hi Stephane,

Thanks for your response. Please see inline..

On Thu, Jan 17, 2019 at 3:27 PM 
<stephane.litkow...@orange.com<mailto:stephane.litkow...@orange.com>> wrote:
Hi,

I think that the fact that “control” packets can benefit of FRR is really 
implementation dependent. It is also linked to the place where BFD packets are 
created (RP or LC).
From a theoretical point of view, nothing prevents FRR to be used as for any 
packet generated by the router itself.

Do we know of any implementation that provides RLFA FRR protection to multihop 
BFD packets?

Regarding the encapsulation, if your BFD client is using RFC5883, this will not 
change during FRR, the FRR will just push labels on top independently.

The primary reason for my question on encapsulations is because RFC 4379 has 
the foll. as one of the reasons for using the destination address in 127/8 
range for IPv4 (0:0:0:0:0:FFFF:7F00/104 range for IPv6) for diagnostic packets 
sent over MPLS LSP:
   1. Although the LSP in question may be broken in unknown ways, the
      likelihood of a diagnostic packet being delivered to a user of an
      MPLS service MUST be held to an absolute minimum.

Since multihop BFD uses a routable destination address, wondering whether there 
would be any issues if multihop BFD packets are sent over the RLFA backup path 
without following RFC 5884 encapsulation..

Regards,
Muthu

Again, the possibility to get FRR is really implementation dependent, as the 
forwarding decision of the BFD packet may not be taken by the network processor 
of the LC.

Brgds,

From: Rtg-bfd 
[mailto:rtg-bfd-boun...@ietf.org<mailto:rtg-bfd-boun...@ietf.org>] On Behalf Of 
Muthu Arul Mozhi Perumal
Sent: Thursday, January 17, 2019 10:16
To: rtg-bfd@ietf.org<mailto:rtg-bfd@ietf.org>
Subject: Can Multihop BFD be protected using RLFA backup?

Hi All,

Multihop BFD (RFC 5883) packets are sent over UDP/IP. The encapsulation used is 
identical to single hop BFD (RFC 5881) except that the UDP destination port is 
set to 4784.

Now, suppose on the ingress node there is no IP/LFA backup path for the 
destination address tracked by multihop BFD, but there exists an an RLFA backup 
path to that destination. In this case, is multihop BFD expected to be 
protected using the RLFA backup path i.e should multihop BFD packets be sent 
over the RLFA backup path if the primary path goes down?

If multihop BFD packets are to be sent over the RLFA backup path, what 
encapsulation should the ingress use? The encapsulation specified in RFC 5883 
or the encapsulation specified in RFC 5884 (MPLS BFD)?

Please let me know you opinion.

Regards,
Muthu

_________________________________________________________________________________________________________________________



Ce message et ses pieces jointes peuvent contenir des informations 
confidentielles ou privilegiees et ne doivent donc

pas etre diffuses, exploites ou copies sans autorisation. Si vous avez recu ce 
message par erreur, veuillez le signaler

a l'expediteur et le detruire ainsi que les pieces jointes. Les messages 
electroniques etant susceptibles d'alteration,

Orange decline toute responsabilite si ce message a ete altere, deforme ou 
falsifie. Merci.



This message and its attachments may contain confidential or privileged 
information that may be protected by law;

they should not be distributed, used or copied without authorisation.

If you have received this email in error, please notify the sender and delete 
this message and its attachments.

As emails may be altered, Orange is not liable for messages that have been 
modified, changed or falsified.

Thank you.

___________________________________________________________________________

This e-mail message is intended for the recipient only and contains information 
which is 
CONFIDENTIAL and which may be proprietary to ECI Telecom. If you have received 
this 
transmission in error, please inform us by e-mail, phone or fax, and then 
delete the original 
and all copies thereof.
___________________________________________________________________________

Reply via email to