At startup, and when loading new files, Rosegarden sends a 'reset all' message. Is there any way to stop this?
The particular scenario that had me puzzled for a while is as follows: I have a Yoshimi file with a set of voice parameters and a Rosegarden one with a complete song project I load up Yoshimi and open its mixer panel. The instruments are there but all the volume and pan setting are the defaults. I load up Rosegarden and see all the sliders move to the positions as set by Rosegarden, but then instantly revert to the defaults! If I run exactly the same files on a different (older) architecture the setting are correct. Has the order of these setting in Rosegarden changed at some point or possibly, are they so close together that some timing issue in the machine can swap them over? My workaound at the moment is to duplicate the controls at the start of each track (I always start at bar 2 to give me some wiggle room). -- W J G ------------------------------------------------------------------------------ _______________________________________________ Rosegarden-user mailing list [email protected] - use the link below to unsubscribe https://lists.sourceforge.net/lists/listinfo/rosegarden-user
