First things first: you really need to allow a little more than 3.75 hours
between posting and reposting. Many (most) potential respondents don't
read the list around the clock, and allowing at least 24 hours between
reposts would (a) potentially allow everyone to see and respond to your
original message, and (b) appear a little less "whiny".
As to the actual problem, it might help if you were to include any messages
that you see when your SCSI driver loads. ("dmesg |more" will pull up your
boot time messages.) As an example, I see the following on my box:
SCSI subsystem driver Revision: 1.00
DC395x (TRM-S1040) SCSI driver 1.40, 2002-05-10
DC395x: Used settings: AdapterID=07, Speed=0(20.0MHz), DevMode=0x57
DC395x: AdaptMode=0x0f, Tags=4(16), DelayReset=1s
DC395 : Connectors: int50 Termination: Auto Low High
DC395: Performing initial SCSI bus reset
DC395x (TRM-S1040): 1 adapters found
scsi0 : Tekram DC395U/UW/F DC315/U V1.40, 2002-05-10
Vendor: HP Model: C1533A Rev: A612
Type: Sequential-Access ANSI SCSI revision: 02
On Thu, 14 Nov 2002 10:11:35 +1300, Mikevl wrote:
>Hi
>
>I have just installed a new tape drive on Redhat 7.2
>The controller is an Initio 9100U/W and the drive is a Tandberg SLR60
>
>The system has recognised the SCSI controller but has no entries for the
>tape drive and so st0 does not work.
>
>Any suggestions?
>
>Many thanks
>
>Mike
--
redhat-list mailing list
unsubscribe mailto:redhat-list-request@;redhat.com?subject=unsubscribe
https://listman.redhat.com/mailman/listinfo/redhat-list
