I can not boot up with a stock kernel 2.4.18-10 with this card, I get this
during bootup:
Loading scsi_mod module
SCSI subsystem driver Revision: 1.00
Loading sd_mod module
kmod: failed to exec /sbin/modprobe -s -k scsi_hostadapter, errno = 2
Loading aha1542 module
Unable to determine Adaptec DMA priority. Disabling board
/lib/aha1542.o: init_module:
Hint: insmod errors can be caused by incorrect module parameters, including
invalid IO or IRQ parameters
ERROR: /bin/insmod exited abnormally!
However, if I recompile the kernel and just enable the AHA-1542 built into
the kernel (as opposed to a module), it comes up just fine:
Configuring Adaptec (SCSI-ID 7) at IO:330, IRQ 10, DMA priority 7
aha1542.c: Using extended bios translation
scsi0 : Adaptec 1542
I hate to have to re-compile the kernel every time there's a new one out,
so is there anything I can do to the stock release (which uses modules) to get
this card to work at bootup?
--
W | I haven't lost my mind; it's backed up on tape somewhere.
+--------------------------------------------------------------------
Ashley M. Kirchner <mailto:[EMAIL PROTECTED]> . 303.442.6410 x130
IT Director / SysAdmin / WebSmith . 800.441.3873 x130
Photo Craft Laboratories, Inc. . 3550 Arapahoe Ave. #6
http://www.pcraft.com ..... . . . Boulder, CO 80303, U.S.A.
--
redhat-list mailing list
unsubscribe mailto:[EMAIL PROTECTED]?subject=unsubscribe
https://listman.redhat.com/mailman/listinfo/redhat-list
