I have a Sony Tape Stacker attached to an adaptec 2940UW. When booting it detected the medium changer and the tape drive. Also, if I 'cat /proc/scsi/scsi' I get the following:
Attached devices: Host: scsi0 Channel: 00 Id: 04 Lun: 00 Vendor: SONY Model: TSL-A500C Rev: L201 Type: Sequential-Access ANSI SCSI revision: 02 Host: scsi0 Channel: 00 Id: 04 Lun: 01 Vendor: SONY Model: TSL-A500C Rev: L201 Type: Medium Changer ANSI SCSI revision: 02 However, I cannot determine what device it is configured as, and also Netbackup was unable to detect any storage devices in the system. The tape drive was previously working fine attached to a Sun system running NetBackup 4.5. Anyone have any suggestions, I an no guru when it comes to configuring devices in Linux. In Sun, you explicitly tell the kernel to probe for specific targets and luns, which is controlled by an ascii file. I see nothing like this in Linux. Thx, Chuck _______________________________________________ Redhat-list mailing list [EMAIL PROTECTED] https://listman.redhat.com/mailman/listinfo/redhat-list
