Hi all,
I recently removed SuSE 6.4 from my Compaq Armada E500 and replaced
it with Redhat 6.2 . Since i use my laptop as a workstation on the LAN , i
need
to get my PCMCIA configured quickly.
As with my previous installation, i downloaded pcmcia-cs-3.1.21.tar.gz and
ran the usual
make config, make all , make install routine . This had got my D-Link
DFE-650 configured
under SuSE but there's a problem under RH.
At bootup i get the following message :
Bringing up interface eth0 delaying eth0 initialisation [failed]
I've checked /var/log/messages : it says ' card services release does not
match'
My /etc/sysconfig/pcmcia says : PCMCIA=yes AND PCIC=i82365
My card IS listed in /etc/pcmcia config
When I manually activate eth0 with netcfg, the card works fine ! I can ping
my eth0 IP 192.168.1.254
But after a reboot it gets deactivated.. What do I try next ?
Anurag
_______________________________________________
Redhat-list mailing list
[EMAIL PROTECTED]
https://listman.redhat.com/mailman/listinfo/redhat-list
