check your path statement(s) or just 'echo $PATH' and see if the sbin dir
is in your path.
> -----Original Message-----
> From: Mike Bull [mailto:[EMAIL PROTECTED]]
> Sent: Thursday, June 08, 2000 7:35 AM
> To: [EMAIL PROTECTED]
> Subject: RE: Connection status?
>
>
> I'm a new chap on the Linux front. I tried using the ifconfig command but
> got the following message
> 'bash:ifconfig:command not found' even though it exists in the sbin
> directory. I've had this with several other commands and I know
> I'm missing
> something really basic.
>
> Help!
>
>
> -----Original Message-----
> From: Kevin Rooney [mailto:[EMAIL PROTECTED]]
> Sent: 08 June 2000 14:04
> To: '[EMAIL PROTECTED]'
> Subject: RE: Connection status?
>
>
> ifconfig -a for all interfaces or ifconfig -whateverinterface i.e. eth0
> netstat also provides some good current info.
>
> -->-----Original Message-----
> -->From: Simons [mailto:[EMAIL PROTECTED]]
> -->Sent: Thursday, June 08, 2000 8:35 AM
> -->To: [EMAIL PROTECTED]
> -->Subject: Connection status?
> -->
> -->
> -->Hello,
> -->
> -->I'm using 3c90x module in rh6.0, is there any utils to know
> -->the connection
> -->status?
> -->For example, connected as 10 or 100Mbps, half or full duplex.
> -->
> -->Thank you.
> -->
> -->best rgds,
> -->Simons
> -->
> -->
> -->
> -->
> -->
> -->--
> -->To unsubscribe: mail [EMAIL PROTECTED] with
> -->"unsubscribe"
> -->as the Subject.
> -->
>
>
> --
> To unsubscribe: mail [EMAIL PROTECTED] with "unsubscribe"
> as the Subject.
>
--
To unsubscribe: mail [EMAIL PROTECTED] with "unsubscribe"
as the Subject.
