Many thanks for all the suggestions!
I've removed the append command from lilo.conf, but that didn't help.
So I didn't try the 'append="mem=127M"' suggestion.
Adding the disk=/dev/sda and bios=0x81 didn't help either.
I haven't had the type to open up the PC and try moving the IDE drive
to the 2nd IDE channel, but that's the next thing I'll do.
Thanks again,
>I've got Redhat 6.2 installed on a 17GB IBM Ultra SCSI hard drive
>connected to a TekRam 390B (Symbios chipset) SCSI controller.
>
>Until the following events, I was able to boot into Linux from the
>SCSI hard drive (/dev/sda) which held the boot partition (/boot on
>/dev/sda1). I recently added a 13GB Maxtor IDE drive as supplemental
>storage. I also added an Adaptec 2901 PCI SCSI controller (no
>boot-rom, external connector only).
>
>I discovered that only 64MB of the installed 128MB RAM was
>recognized. I edited lilo.conf and added 'append = "mem=128M" and
>ran lilo and I got a message "Warning: /dev/sda is not on the first
>disk".
>
>When I rebooted the PC, lilo freezes after "LI".
>
[snip]
--
To unsubscribe: mail [EMAIL PROTECTED] with "unsubscribe"
as the Subject.
