On Wed, Mar 22, 2000 at 03:52:20PM +0000, jon wrote:
:
: I have tried searching the redhat site and found nothing specific. Where can I
: find SPECIFIC instructions to get RH6.0/6/1 installed on an EXISTING
: Windows2000 Pro installation. I am looking for something which is UPTO DATE
: and not some old howto from 1997 and the first revision of NT4.
:
: A little side info....
:
: I have a 4.2GB IDE drive sitting at the first device (IDE-0). There is a little
: 300mb fat32 partition there from an existing Win98 install. The remaining 3.9GB
: is unclaimed and awaiting RH Linux. Win2K resides on two other scsi devices.
: Win98SE + RH6.0 was an easy dual boot config but I can't afford to screw up the
: existing Win2K install.
I'll assume that you have the ability to select 98 or 2000 from the
win2k bootloader.
Install lilo in the mbr of your boot drive. You'll choose between Linux
and the Win2k bootloader, at which time you can choose to boot win98.
--
Jason Costomiris <><
Technologist, cryptogeek, human.
jcostom {at} jasons {dot} org | http://www.jasons.org/
--
To unsubscribe: mail [EMAIL PROTECTED] with "unsubscribe"
as the Subject.
