I am trying to set up a second eth nic to connect to ADSL modem. I
finally did a new server install. When I boot up, the program sees the
eth1 card, but it fails. It was not set up during the new install. My
question is should it be set up during fresh install? I am thinking I
may have a bad card. It is a linksys NC100 model, pci, tulip driver. I
am using Red Hat 6.0.
I did try adding the card after install, made changes in kernel using
desktool. I,m stumpped.:-(
Any help would be appreciated.
Kerry
--
To unsubscribe: mail [EMAIL PROTECTED] with "unsubscribe"
as the Subject.
