<<<_X11TransSocketUNIXConnect: Can't connect: errno = 111
<<<Fatal configX error:
<<<Cannot open Display or start X server
<<</mnt/cdrom/metrolink> _X11TransSocketUNIXConnect: Can't connect
Ezekiel:
I believe what this means is that you may have not defined the parameters of your
display. I had the same problem.
If you have RH5.0, and you have not yet read the manual, then go to page 97 and you
need to run your configX.curses. It will take you through a list of cards. You can
also use configX by typing /usr/bin/X11/configX (page 98)
If you did not select the proper video card when you installed, then you need to
install this Xconfigurator.
Just go to page 94 and read that chapter and it will answer all your questions...
Hope this helps.
Michael Hatzakis, Jr MD
Resident Physiatrist - R3
Thomas Jefferson University Hospital
Department of Rehabilitation Medicine
Philadelphia, PA, 19026
E-Mail Address: [EMAIL PROTECTED]
--
PLEASE read the Red Hat FAQ, Tips, Errata and the MAILING LIST ARCHIVES!
http://www.redhat.com/RedHat-FAQ /RedHat-Errata /RedHat-Tips /mailing-lists
To unsubscribe: mail [EMAIL PROTECTED] with
"unsubscribe" as the Subject.
