I occassionally get errors (don't remember if it was this exact error) on my
flash cards when they are blank. I find that formatting them again helps. You
can use your camera to do this, assuming you're using this for a camera. Once
formatted properly, they mount up fine. If you have another CF card, try that
one as a test. Generally, though, my pcmcia+cf worked right off the
bat...once I figured out which /dev/ it was on. ;)
<<JAV>>
---------- Original Message -----------
From: Bill Heese <[EMAIL PROTECTED]>
To: [EMAIL PROTECTED]
Sent: Mon, 4 Aug 2003 21:09:51 -0700 (PDT)
Subject: Compact Flash Cards & PCMCIA
> I've been trying to mount a LexarMedia Compact flash
> card via the PCMCIA port and keep getting the
> following error. Any help would be greatly
> appreciated. Thanks in Advance.
>
> Bill
>
> USB Mass Storage device found at 2
> hde: LEXAR ATA_FLASH, CFA DISK drive
> ide2 at 0x100-0x107,0x10e on irq 3
> ide-floppy driver 0.99.newide
> hde: attached ide-disk driver.
> hde: task_no_data_intr: status=0x51 { DriveReady
> SeekComplete Error }
> hde: task_no_data_intr: error=0x04 { DriveStatusError
> }
> hde: 16064 sectors (8 MB) w/1KiB Cache, CHS=251/2/32
> hde:
> ide_cs: hde: Vcc = 3.3, Vpp = 0.0
> hde:
> hde: task_no_data_intr: status=0x51 { DriveReady
> SeekComplete Error }
> hde: task_no_data_intr: error=0x04 { DriveStatusError
> }
> hde: Write Cache FAILED Flushing!
> hde:
> hde:
> hde1: bad access: block=0, count=1
> end_request: I/O error, dev 21:01 (hde), sector 0
> FAT: unable to read boot sector
> hde: task_no_data_intr: status=0x51 { DriveReady
> SeekComplete Error }
> hde: task_no_data_intr: error=0x04 { DriveStatusError
> }
> hde: Write Cache FAILED Flushing!
>
> --
> redhat-list mailing list
> unsubscribe mailto:[EMAIL PROTECTED]
> https://www.redhat.com/mailman/listinfo/redhat-list
------- End of Original Message -------
--
redhat-list mailing list
unsubscribe mailto:[EMAIL PROTECTED]
https://www.redhat.com/mailman/listinfo/redhat-list
