I'll exend Brad's comments: 1) is this a RAID controller? If so, then you could have hardware mirroring (RAID 1) and you would only see one device 2) is this narrow or wide SCSI? Narrow SCSI has 8 devices available, 0 to 7, with 7 *usually* being reserved/allocated for the SCSI adaptor itself at ID 7. Narrow SCSI has 15 devices available, 0 to 14, but 7 is still *usually* being reserved/allocated for the SCSI adaptor itself at ID 7.
HTH, Mike ------------------------------------------ Mike Pelley "Non illegitimati carborundum" Owner & "Misc. Rambler" of Pelleys.com [EMAIL PROTECTED] - www.pelleys.com -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Brad Alpert Sent: Saturday, April 05, 2003 6:20 PM To: [EMAIL PROTECTED] Subject: Re: Dead scsi drive or bad set-up? What kind of SCSI controller do you have? All SCSI controllers I've ever seen have always had a setup available that you can get to before bootup. I'd try to get into the setup ROM and see what the controller knows about the drive(s). Brad > > So, I've got this franken-computer I inherited that > supposedly has two scsi drives inside of it, but I've only > ever seen one of them work. If you watch the boot messages, > you can see that there are two devices on the scsi chain, > the boot disk comes in as scsi id 7, and there's another one > at scsi id 15. So as I understand it, there ought to be a > /dev/sdb, but stuff like fdisk and mke2fs has always just > given me "no such device" errors. -- redhat-list mailing list unsubscribe mailto:[EMAIL PROTECTED] https://listman.redhat.com/mailman/listinfo/redhat-list -- redhat-list mailing list unsubscribe mailto:[EMAIL PROTECTED] https://listman.redhat.com/mailman/listinfo/redhat-list
