Eaton has a 125A panel that can take two hold down kits. I happen to be installing three of them today ...
BR816L125RP Blake Gleason, PE | Employee Owner Director of Innovation and Technical Excellence O: 510-845-2997 x128 C: 510-867-5878 [image: sunlightandpower.com] <http://sunlightandpower.com/> <https://linktr.ee/SLP_Socials> 1035 Folger Ave. Berkeley, CA 94710 www.sunlightandpower.com License #326203 <https://benefitcorporationsforgood.com/> [image: https://www.amicussolar.com/] <https://www.amicussolar.com/> [image: https://calssa.org/] <https://calssa.org/> On Wed, Sep 24, 2025, 1:37 PM Jason Szumlanski via RE-wrenches < [email protected]> wrote: > I have a situation with a utility company that requires us to have a > single visible load break disconnect switch that isolates only the > "renewable sources" without disconnecting the house loads. To do this, the > only way possible seems to be combining the inverters in a load center and > then using the main lugs in the load center to go to a fusible disconnect > switch, and then the backup load lugs in the Gateway 3. > > The problem with that is I have not been able to find a 125 amp load > center that accepts multiple backfed breaker fasteners. Square D has a 100 > amp load center that accepts two breaker hold down kits, but for two > Powerwalls we need 125A. > > Other than going to a panel board with bolt on breakers, can you think of > any other way to comply? > > Jason Szumlanski > Florida Solar Design Group > We > > _______________________________________________ > List sponsored by Redwood Alliance > > Pay optional member dues here: http://re-wrenches.org > > List Address: [email protected] > > Change listserver email address & settings: > http://lists.re-wrenches.org/options.cgi/re-wrenches-re-wrenches.org > > There are two list archives for searching. When one doesn't work, try the > other: > https://www.mail-archive.com/[email protected]/ > http://lists.re-wrenches.org/pipermail/re-wrenches-re-wrenches.org > > List rules & etiquette: > http://www.re-wrenches.org/etiquette.htm > > Check out or update participant bios: > http://www.members.re-wrenches.org > >
_______________________________________________ List sponsored by Redwood Alliance Pay optional member dues here: http://re-wrenches.org List Address: [email protected] Change listserver email address & settings: http://lists.re-wrenches.org/options.cgi/re-wrenches-re-wrenches.org There are two list archives for searching. When one doesn't work, try the other: https://www.mail-archive.com/[email protected]/ http://lists.re-wrenches.org/pipermail/re-wrenches-re-wrenches.org List rules & etiquette: http://www.re-wrenches.org/etiquette.htm Check out or update participant bios: http://www.members.re-wrenches.org
