It’s not required but it has the only reliable means of generator start stop. There are three relays that can be programmed. You can’t get accurate battery state of charge by using voltage except near empty or full. The LynkII also has a little bar graph showing state of charge to the nearest 10%. Unfortunately it does not connect to a LAN yet.
Sent from my iPhone > On Jan 10, 2023, at 10:06 AM, Jeremy Rodriguez via RE-wrenches > <re-wrenches@lists.re-wrenches.org> wrote: > > Is the Lynx II gateway required for battery to battery comms? > Model 42-48-6650 > We will be installing with an inverter that cannot communicate. > > > > Jeremy Rodriguez > Solar Installation / Design > All Solar, Inc. > 1453 M St. > Penrose Colorado 81240 > > Sent by Jeremy's iPhone. Sorry for typos and shorthand. > _______________________________________________ > List sponsored by Redwood Alliance > > Pay optional member dues here: http://re-wrenches.org > > List Address: RE-wrenches@lists.re-wrenches.org > > Change listserver email address & settings: > http://lists.re-wrenches.org/options.cgi/re-wrenches-re-wrenches.org > > There are two list archives for searching. When one doesn't work, try the > other: > https://www.mail-archive.com/re-wrenches@lists.re-wrenches.org/ > http://lists.re-wrenches.org/pipermail/re-wrenches-re-wrenches.org > > List rules & etiquette: > http://www.re-wrenches.org/etiquette.htm > > Check out or update participant bios: > http://www.members.re-wrenches.org > _______________________________________________ List sponsored by Redwood Alliance Pay optional member dues here: http://re-wrenches.org List Address: RE-wrenches@lists.re-wrenches.org Change listserver email address & settings: http://lists.re-wrenches.org/options.cgi/re-wrenches-re-wrenches.org There are two list archives for searching. When one doesn't work, try the other: https://www.mail-archive.com/re-wrenches@lists.re-wrenches.org/ http://lists.re-wrenches.org/pipermail/re-wrenches-re-wrenches.org List rules & etiquette: http://www.re-wrenches.org/etiquette.htm Check out or update participant bios: http://www.members.re-wrenches.org